350-001 Exam

The latest Cisco 350-001 exam dumps free demo:

1. Which of these is mandatory when configuring Cisco IOS Firewall?
A. Cisco IOS IPS enabled on the untrusted interface
B. NBAR enabled to perform protocol discovery and deep packet inspection
C. a route map to define the trusted outgoing traffic
D. a route map to define the application inspection rules
E. an inbound extended ACL applied to the untrusted interface
Answer: E
2. Refer to the exhibit. In this network, R1 has been configured to advertise a summary route, 192.168.0.0/22, to R2. R2 has been
configured to advertise a summary route, 192.168.0.0/21, to R1. Both routers have been configured to remove the discard route (the route
to null created when a summary route is configured) by setting the administrative distance of the discard route to 255.
What will happen if R1 receives a packet destined to 192.168.3.1?
A. The packet will loop between R1 and R2.
B. It is not possible to set the administrative distance on a summary to 255.
C. The packet will be forwarded to R2, where it will be routed to null0.
D. The packet will be dropped by R1, since there is no route to 192.168.3.1.
Answer: A
3. What is the purpose of an explicit "deny any" statement at the end of an ACL?
A. none, since it is implicit
B. to enable Cisco IOS IPS to work properly; however, it is the deny all traffic entry that is actually required
C. to enable Cisco IOS Firewall to work properly; however, it is the deny all traffic entry that is actually required
D. to allow the log option to be used to log any matches
E. to prevent sync flood attacks
F. to prevent half-opened TCP connections
Answer: D
4. The classic Spanning Tree Protocol (802.1D 1998) uses which sequence of variables to determine the best received BPDU?
A. 1) lowest root bridge id, 2) lowest sender bridge id, 3) lowest port id, 4) lowest root path cost
B. 1) lowest root path cost, 2) lowest root bridge id, 3) lowest sender bridge id, 4) lowest sender port id
C. 1) lowest root bridge id, 2) lowest sender bridge id, 3) lowest root path cost 4) lowest sender port id
D. 1) lowest root bridge id, 2) lowest root path cost, 3) lowest sender bridge id, 4) lowest sender port id
Answer: D
5. What is the purpose of the STP PortFast BPDU guard feature?
A. enforce the placement of the root bridge in the network
B. ensure that a port is transitioned to a forwarding state quickly if a BPDU is received
C. enforce the borders of an STP domain
D. ensure that any BPDUs received are forwarded into the STP domain
Answer: C

buy 350-001 dumps in Gousex,you can pass it in the first try.100% pass guarantee.